ASSESSMENT OF FIBRE CHARACTERISTICS OF SPONDIA MOMBIN L. (ANACARDIACEAE) FOR PULP AND PAPER PRODUCTION

Authors

  • E. T. Tembe
  • David Oriabure Ekhuemelo
    Federal University of Agriculture, Makurdi.
  • B. T. Aondoaver

Keywords:

Wood slivers, Glatial acetic acid, Fibre Characteristics, Derived Fibre indices

Abstract

The fibre characteristics of five Spondia mombin stands were studied to determine their suitability for pulp and paper production. Wood slivers obtained parallel to grain at three (3) different positions along the bole were macerated in combined identical amounts of glacial acetic acid plus hydrogen peroxide under heat at between 80-100o C. Macerated fibres were washed clean of mixture and mounted on slide for microscopic examination of fibre characteristics. Completely Randomized Design (CRD) was employed for the experiment. Data were analysed using one-way Analysis of Variance (ANOVA) while, the Duncan’s Multiple Range Test (DMRT) was used to separate means of significant differences among the treatments. Results show that significant differences existed in fibre characteristic of sampled trees, however the fibre length ranged from 0.98-1.0 mm, fibre diameter (18.22-21.47 um), lumen width (10.90-12.98 um) and cell wall thickness (3.86-4.60 um). Significant differences were also observed among the derived fibre characteristics, the Runkel ratio ranged from 0.66-8.89, elasticity coefficient (57.22-60.50 %), coefficient of rigidity (19.78-22.24 %), slenderness ratio (43.27-46.5). This implied that, the fibres of S. mombin were short and elastic which make the wood species an appropriate raw material for pulp and paper making especially when blended with other long fibre species.

Dimensions

Ajala, O. O. (1997). Evaluation of wood and fibre characteristics of Nigerian grown Pinus carribea, Department of Forest Resources Management, University of Ibadan, Ibadan, Nigeria. Thesis, Pp137.

Akgul, M. and Tozluoglu, A. (2009). Some Chemical and Morphological Properties of Juvenile Woods from Beech (Fagus orientalis L.) and Pine (Pinus nigra A.) Plantations. Trends in Applied Sciences Research, 4: 116-125.

Amidon, T. E. (1981). Effect of the wood properties of hardwoods on kraft paper properties. Tappi, 64: 123-126.

Andall, R. and Paull, R. E. (2012). Spondias mombin (Yellow mombin). In: The Encyclopedia of Fruit and Nuts. J. Janick and R. E. Paull, editors. CABI International, Cambridge, MA. P. 31–34.

Anon (1984). Chemical Analysis of Nigerian Grown timbers. Annual Report of the Forestry Research Institute of Nigeria. Jan. - Dec., p. 108-109.

Ashori, A. and Nourbakhsh, A. (2009). Studies on Iranian cultivated Paulownia: a potential source of fibrous raw material for paper industry. European Journal of Wood and Wood Products, 67: 323-327.

Ates, S., Ni, Y., Akgul, M. and Tozluoglu, A. (2008). Characterization and evaluation of Paulownia elongata as a raw material for paper production. African Journal of Biotechnology, 7 (22): 4153 - 4158.

Bektas, I, Titus, A. and Broglue, H. (1999). A study of the suitability of calabrain pine (pinusbrutiaten) for pulp and paper manufacture. Turkey Journal of Agriculture and Forestry, 23: 589-599.

Dinwoodie, J. M. (1965). The relationship between ï¬bre morphology and paper properties of: A Review of Literature. Tappi, 48: 440-447.

Duncan, D. B. (1955). Multiple Range and Multiple F- test. Biometrics. 11:1-42.

Emerhi, E. A. (2012). Variations in anatomical properties of Rhizophoraracemosa (Leechm) and Rhizophora harrisonii (G. Mey) in a Nigerian mangrove forest ecosystem. International Journal of Forest, Soil and Erosion, 2 (2): 89-96.

Ezeibekwe, I. O., Okeke, S. E., Unamba, C. I. and Ohaeri, J. C. (2009). An Investigation into the potentials of Dactyladenia bacteri; Dialum guineense; and Anthonotama crophylia for Paper Pulp Production. Report and Opinion, 1 (4): 18-25.

Hudson, I., Wilson,, L. and Beveren, K. V. (1998). Vessel and fiber property variation in Eucalyptus globulus and Eucalyptus nitens: some preliminary results. IAWA Journal, 19: 111-130.

Hus, S., Tank, T. and Goksal, E. (1975). Considering Eucalyptus (E: camaldulensis Dhnh). Wood which grow in Turkey (in Tarsus-Karabacak). Morphology and opportunity for evaluating semi chemical cellulose in paper industry. Tubitak Publication, USA.

Izekor, D. N. and Fuwape, J. A. (2011).Variations in the anatomical characteristics of plantation grown Tectona grand is wood in Edo State, Nigeria. Archives of Applied Science Research, 3 (1): 83-90.

Izekor, D. N. and Fuwape, J. A. (2011). Variations in the anatomical characteristics of plantation grown Tectona grandis wood in Edo State, Nigeria. Archives of Applied Science Research, 3 (1): 83-90.

Kami, P. G. K. (1969). Genbokuï½¥Chouboku (Log and log preparation). Kami parupu gijutsu kyokai (Japan Technical Association of the Pulp and Paper Industry), Tokyo.

Mercy, O. B., Adeola, F. J., Olajide, O. A., Babatunde, A. and Sunday, F. J. (2017). Evaluation of fibre characteristics of Ricinodendron heudelotii (Baill, Pierre Ex Pax) for pulp and paper making. International Journal of Scientific and Technology Research, 6 (1): 634-641.

Metcalfe, C. R. and Chalk, L. (1983). Anatomy of the dicotyledons 2, 2. Nordic Journal of Botany, 4 (5): 668- 668.

Obiora, D. N., Ajala, A. E. and Ibuot, J. C. (2015). Investigation of groundwater flow potential in Makurdi, North Central Nigeria, using surficial electrical resistivity method. African Journal of Environmental Science and Technology, 9(9): 723-733.

Ogunleye, B. M, Fuwape, J. A, Oluyege, A.O., Agayi, B. and Fabiyi, J. S. (2017). Evaluation of fibre characteristics of Ricinodedron heudelotic (bail, pierre ex pax) for pulp and paper making. International Journal of Science and Technology, 6(1): 684-636.

Ogunkunle, A. T. J. (2010). A Quantitative Modeling of Pulp and Paper Making Sustainability of Nigerian Hardwood Species. Advances in Natural and Applied Sciences, 4 (1): 14-21.

Ojo, D. O. (2013). Determination of Pulp and Paper Making Suitability Indices of Some Nigerian Species of Leguminosae: Caesalpinoideae. Academic Journal of Interdisciplinary Studies, 2 (13): 61-68.

Oluwadare, A. O. (1998). Evaluation of the Fibre and Chemical Properties of some Selected Nigerian Wood and Non-wood species for Pulp Production. Journal of Tropical Forest Research, 14: 110-119. 27.

Oluwadare, A. O. (1998). Evaluation of the Fibre and Chemical Properties of Some Selected Nigerian Wood and Non-Wood Species for pulp production. Journal of Tropical Forest Science, 14: 110- 119.

Ona, T., Sonoda, T., Ito, K., Shibata, M., Tamal, Y., Kosima, Y., Ohshima, Yokota, S. and Yoshinzawa, N. (2001). Investigation of relationship between cell and pulp properties in Eucalyptus by examination of tree variations. World Science and Technology, 35: 229-243.

Osadare, A. O. (2001). Basic wood and pulp properties of Nigerian-grown Caribbean pine (Pinus caribaea Morelet) and their relationship with tree growth indices. Ph.D. thesis University of Ibadan. p.347.

Panshin, A. and De Zeeuw, C. (1980). Textbook of Wood Technology. 4th edition, McGrawth-Hill, New York. Pp 722.

Roger, M. R., Mario, T. F. and Edwin, C. A. (2007). Fiber morphology in fast growth Gmelina arborea plantations. Madera y Bosques, 13 (2): 3-13.

Shakhes, J., Zenaly, F, Marandi, M. A. B. and Sagafi, T. (2011). The effect of processing variable on the soda and soda AQ pulping of kenafbastfibre, Bioresources, 6 (9): 4626-4639.

Sharma, M., Sharma, C. L. and Kumar, Y. B. (2013). Evaluation of fiber characteristics in some weeds of Arunachal Pradesh, India for pulp and paper making. Research Journal of Agriculture and Forestry Sciences, 1 (3): 15-21.

Takeuchi, R., Wahyudi, I., Aiso, H.,Ishiguri, F., Istikowati, W. T., Ohkubo, T., Ohshima, J., Iizuka, K. and Yokota, S. (2016). Wood properties related to pulp and paper quality in two Macaranga species naturally regenerated in secondary forests, Central Kalimantan, Indonesia, Tropics, 25 (3): 107-115.

Tembe, E. T., Amonum, J. I. and Shomkeg, S. A. (2010). Variations in fibre length of rubber wood (Hevea brasiliensis (kunth) Muel Arg) grown in south east Nigeria. Journal of Research in Forestry, Wildlife and Environment, 2 (2): 214-220.

Tembe, E. T., Ekhuemelo, D. O. and Joseph, E. O. (2020). Evaluation of Fibre Morphological of Rice (Oryza sativa) Varieties Grown in Makurdi, Benue State, for their

suitability in Pulp and Paper Production (Eds., B. O. Agbeja, O. V. Oyerinde, J. A. Olusola and O. S. Olaniran) Proceedings of the 3 rd Annual Conference of the Commonwealth Forestry Association, Nigeria Chapter, Federal university of Technology, Akure, Nigeria 06 - 11 June, 2020, Pp. 36-41.

Uchendu, C. N. and Isek, T. (2008). Antifertility activity of aqueous ethanolic leaf extract of Spondias mombin (Anacardiaceae) in rats. African Health Sciences, 8 (3): 163-167

Usta, M. and Eroglu, H. (1987). Soda-Oxygen Pulping Rye Straw. In: Non-wood plant fibre conference. Washington DC. TAPPI press, progress report. 18: 113-118.

Xue Zhang, F. C., Sun, R. C. and Lu, Q. (2006). Anatomy, ultrastructure and lignin distribution in cell wall of Caragana korshinskii. Industrial Crops and Products, 24: 186-193.

Published

29-06-2021

How to Cite

ASSESSMENT OF FIBRE CHARACTERISTICS OF SPONDIA MOMBIN L. (ANACARDIACEAE) FOR PULP AND PAPER PRODUCTION. (2021). FUDMA JOURNAL OF SCIENCES, 5(1), 511-516. https://doi.org/10.33003/fjs-2021-0501-597

Issue

Vol. 5 No. 1 (2021): FUDMA Journal of Sciences - Vol. 5 No. 1

Section

Research Articles
Copyright & Licensing

FUDMA Journal of Sciences

How to Cite

ASSESSMENT OF FIBRE CHARACTERISTICS OF SPONDIA MOMBIN L. (ANACARDIACEAE) FOR PULP AND PAPER PRODUCTION. (2021). FUDMA JOURNAL OF SCIENCES, 5(1), 511-516. https://doi.org/10.33003/fjs-2021-0501-597

Most read articles by the same author(s)